“Super Prism” Throttle Cable for Prism Throttle Assemblies – 30 inch

Specially set up for the “Super Prism” Throttle Assembly Manufactured by Barnett Stock cable length is 30″ Also available in 40″ Comes with cable stop and lube THROTTLE & IDLE CABLE MEASUREMENTS Cable End Type Push In Elbow Length 4-1/4″ Elbow Angle 45 degree Housing Length 30″ Free Play 5″ THROTTLE & IDLE CABLE MEASUREMENT DEFINITIONS See the example diagram above to see how this cable is measured. Note that the diagram is just an example, and is not a drawing of this exact cable! Also, there can be variations of these measurements by /- .25″ (6mm) due to manufacturing tolerances. Elbow Length: Overall length of elbow section, if there is one. Elbow Angle: 45 degree, 90 degree, or N/A (no elbow) Housing Length: Overall length of cable housing, not including adjuster or elbow. Measurement stops at elbow where black housing meets chrome. Free Play: The full amount of travel of the inner cable. Pull inner cable fully to one side, measure length, not including cable end (ferrule) or return spring.